Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Stationary solution as initial values for transient analysis (thermo-mechanical)
Posted 16.08.2017, 09:45 GMT-4 Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I've been facing a problem for I while, and I would appreciate any help for this issue.
Basically, I have to components, I apply a pre-compression to the external boundaries of one of them and compute the contact pressure existing in both (see attached pictures). Then, I would like to use this solution (deformation and contact pressure) as a point of start in a transient (not necessarily transient?) thermo-mechanical analysis and see how the contact pressure is being relieved.
I am able to compute both studies separately, but without success when it comes to couple both studies.
I've seen that under "Dependent Variables", and activating "initial values for variables solved for", I can select the solution given by the stationary solver, but It doesn't work.
Any suggestions?
PS. It would be nice if someone could explain the detailed steps to follow.
Thanks in advance
Hello Guillermo Alejandro Barraza Montiel
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.