Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Extracting Length of Boundary
Posted 14.06.2017, 12:05 GMT-4 2 Replies
Please login with a confirmed email address before reporting spam
At the end of my simulation, I take a "Line Average" of a few of my boundaries. I click on the *one* boundary I want to inspect, then get "es.nD" and "V" parameters for the boundary when I hit "evaluate". My solution is a parametric sweep, so it gives me those values for every parameter in my sweep.
Extracting the length requires me to go back into my geometry and measure each length individually for each parameter and then match everything up. I could also calculate it based on the parameters I set, but again I would have to match it up afterwards.
Is there some variable that will just return the length of my boundary?
Extracting the length requires me to go back into my geometry and measure each length individually for each parameter and then match everything up. I could also calculate it based on the parameters I set, but again I would have to match it up afterwards.
Is there some variable that will just return the length of my boundary?
2 Replies Last Post 14.06.2017, 13:10 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Hi Thomas,
Integrating 1 along a line will give you its length.
Jeff
Integrating 1 along a line will give you its length.
Jeff
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Awesome! Thank you! :D