Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Heat Transfer - flow
Posted 28.02.2017, 14:23 GMT-5 Fluid & Heat, Heat Transfer & Phase Change Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
Greetings.
I have a Heat transfer modelled, which I'd like to couple to a fluid laminar flow.
I would like to give the flow inlet and outlet conditions on imaginary surfaces on either side of the geometry (as given in the figure) . However, I understood a box selection doesn't work.
Kindly, help me in defining an imaginary surface to give fluid inlet and outlet.
If defining a wall geometry is inevitable, How should I be modelling it, and what material properties shall be assigned to it.
Thanks.
-Sai Phani Kiran
I have a Heat transfer modelled, which I'd like to couple to a fluid laminar flow.
I would like to give the flow inlet and outlet conditions on imaginary surfaces on either side of the geometry (as given in the figure) . However, I understood a box selection doesn't work.
Kindly, help me in defining an imaginary surface to give fluid inlet and outlet.
If defining a wall geometry is inevitable, How should I be modelling it, and what material properties shall be assigned to it.
Thanks.
-Sai Phani Kiran
Attachments:
1 Reply Last Post 28.02.2017, 15:24 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Sai,
The busbar tutorial in the Introduction to COMSOL Multiphysics manual, version 5.2a, explains how to do this with step by steps instructions. All manuals can be accessed through File > Help > Documentation.
Best,
Jeff
The busbar tutorial in the Introduction to COMSOL Multiphysics manual, version 5.2a, explains how to do this with step by steps instructions. All manuals can be accessed through File > Help > Documentation.
Best,
Jeff