Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Averaging multiple cut line 3D
Posted 18.01.2017, 08:36 GMT-5 Heat Transfer & Phase Change Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello everyone,
I am trying to define multiple cut lines 3D in a 3D geometry in height and take the average of them. Meaning, if I have defined 3 lines then take the average of all of them and represent them in only 1 line.
What is the best way to do so without outputting the results separately and take the average manually?
Thank you for your help.
I am trying to define multiple cut lines 3D in a 3D geometry in height and take the average of them. Meaning, if I have defined 3 lines then take the average of all of them and represent them in only 1 line.
What is the best way to do so without outputting the results separately and take the average manually?
Thank you for your help.
1 Reply Last Post 01.02.2017, 09:45 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Arsha,
You could use Component Couplings of the Linear Extrusion type to pass the information from 2 of the lines to the third.
If you have not used Component Couplings before, you'll want to read the section on them in the COMSOL Multiphysics Reference Manual, version 5.2a, page 289 and following.
Best,
Jeff
You could use Component Couplings of the Linear Extrusion type to pass the information from 2 of the lines to the third.
If you have not used Component Couplings before, you'll want to read the section on them in the COMSOL Multiphysics Reference Manual, version 5.2a, page 289 and following.
Best,
Jeff