Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Unable to model shockwaves in comsol

Posted 08.12.2016, 11:45 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.2a 0 Replies

Ben Brooks
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have been attempting to model high speed flow over a cone, however for some reason I cannot get a shockwave to form. The attached image shows the pressure contours at an inlet speed of 2000 m/s, so far above Mach 1.
The atmospheric conditions I used correspond to about 61km altitude, so the pressure is only about 30 pascals however I don't think this is the issue.

Any help would be greatly appreciated!

Thanks,
Ben Brooks
0 Replies Last Post 08.12.2016, 11:45 GMT-5
COMSOL Moderator

Hello Ben Brooks

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content