Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inlet and outlet boundary condition of fluid flow

Posted 09.11.2016, 05:55 GMT-5 Fluid & Heat Version 4.3a 0 Replies

Nidhin T Madhu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am new to Comsol simulation.
I am trying to simulate fluid flow in porous material. The fluid gets accumulated in porous material. Only known volume of fluid is available at inlet reservoir like 5 cb.m . This liquid gets accumulated in another place where it can hold this much quantity of liquid and there should not be any deformation for the material. The flow is driven by pressure from first reservoir to the next.
How to give the inlet and outlet condition for the above problem? How to make simulation understand that only some quantity of liquid is available and the flow should stop when the first reservoir gets emptied?

Thanks in advance

Nidhin
0 Replies Last Post 09.11.2016, 05:55 GMT-5
COMSOL Moderator

Hello Nidhin T Madhu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content