Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric Potential Simulation and validation do not match

Posted 28.10.2016, 03:35 GMT-4 Low-Frequency Electromagnetics Version 5.2 2 Replies

Thomas Bender
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi @ all,
i made a simulation of an electric potential in a chamber with a liquid.
Material properties:

liquid:
sigma: 0.114 S/m
epsilon_r: 1.08E+08 (not relevant for electrical potential)

chamber (isolator)
sigma: 10E-12 S/m
epsilon_r: 4

electrodes (Titan)
sigma: 561797.753 S/m
epsilon_r: 1+0.0000033

Physics:

Electric Currents (ec)
with 2 Electric potentials (Ground 0V and the oter 1V)

Study:

Frequency Domain with 20Hz

And the results of the simulation do not match the measured values.
But if i change the electrical conductivity (liquid) to a very very high value of 6000 S/m it match.
What can that be or where is my mistake.

Thanks a lot

Thomas
2 Replies Last Post 01.11.2016, 03:38 GMT-4
Thomas Bender
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 28.10.2016, 03:54 GMT-4
I also test the current through one electrode. With the right conductivity it is nearly like the experiment (11 mA) and with the wrong conductivity of 6000 S/m its way to high (about 55 A).
I also test the current through one electrode. With the right conductivity it is nearly like the experiment (11 mA) and with the wrong conductivity of 6000 S/m its way to high (about 55 A).
Thomas Bender
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 01.11.2016, 03:38 GMT-4
Hello again,

Is there a way to check the conductivity of a liquid by using a simple methods/tools?

thank you and best regards

Thomas

Hello again, Is there a way to check the conductivity of a liquid by using a simple methods/tools? thank you and best regards Thomas

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content