Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Material property of frequency-domain simulation dependent on previous static simulation (small-signal analysis)
Posted 16.09.2016, 05:00 GMT-4 Low-Frequency Electromagnetics, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
When performing a small-signal analysis of a non-linear magnet material (e.g. www.comsol.com/model/small-signal-analysis-of-an-inductor-2128), the linear permeability in the frequency domain is calculated as dB/dH at the operating point on the BH-curve from the static analysis.
However, this results in a considerably higher permeability value than what I think is correct for small signal excitations, i.e. before saturation of the material. The attached figure (from a scientific paper) illustrates that the slope of a minor BH-loop, i.e. the recoil permeability is considerably less than dB/dH of the major-loop BH-function (e.g. μrecoil=150 compared to dB/dH=1000).
I would like to maximize the permeability used in the frequency domain analysis to a constant value for all dB/dH values exceeding this value, see second attached fig as example.
Is it at all possible to implement this type of material definition where the permeability of the frequency-domain model is dependent of the H-field value of the previous static simulation?
Thanks for any input on this!
Kind regards,
Johan Gustafsson
Attachments:
Hello Johan Gustafsson
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.