Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Hii everyone
Posted 13.07.2016, 02:29 GMT-4 Fluid & Heat, Chemical Reaction Engineering Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
I am working on comsol 5.0 and am facing problem on passing two fluids (air, liquid solution) through single domain.Even i have tried 2 different inlets and outlets for 2 different fluids but after selecting 1 material in domain the other automatically overidden itself and in results it is not showing mass tranfer or diffusion .
please help me guys in physics selection.
please help me guys in physics selection.
1 Reply Last Post 25.07.2016, 14:43 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Gunendra,
It sounds like you are trying to model a two-phase flow situation. It is not clear from your posting what module(s) your license carries.
A quick introduction to multiphase flow modeling capabilities in the COMSOL software is available here:
www.comsol.com/blogs/which-multiphase-flow-interface-should-i-use/
What fluid flow capability comes with which module is summarized here:
www.comsol.com/products/specifications/fluid-flow/
Best regards,
Jeff
It sounds like you are trying to model a two-phase flow situation. It is not clear from your posting what module(s) your license carries.
A quick introduction to multiphase flow modeling capabilities in the COMSOL software is available here:
www.comsol.com/blogs/which-multiphase-flow-interface-should-i-use/
What fluid flow capability comes with which module is summarized here:
www.comsol.com/products/specifications/fluid-flow/
Best regards,
Jeff