Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems with INLET/OUTLET boundary conditions

Please login with a confirmed email address before reporting spam

Hi everybody,

I have a water purificator reactor which has an inlet and an outlet. I want to stablish the same dispersed phase concentration for the outlet and the inlet. I mean, the dispersed phase concentration that gets in the reactor must be the same that goes out.

How can I do it? What do I have to change in the boundary conditions?

Thank you

Ricardo.

2 Replies Last Post 30.06.2016, 05:38 GMT-4

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 30.06.2016, 05:17 GMT-4
Hi Ricardo,

Can you attach a screenshot of your Physical field setting?

Gonzalo
Hi Ricardo, Can you attach a screenshot of your Physical field setting? Gonzalo

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 30.06.2016, 05:38 GMT-4
Outlet in the left part of the rectangle and inlet in the right part. I want the same concentration por disperse phase in the outlet and in the inlet.

Thanks,

Ricardo
Outlet in the left part of the rectangle and inlet in the right part. I want the same concentration por disperse phase in the outlet and in the inlet. Thanks, Ricardo

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.