Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Conservative strategy on domain

Please login with a confirmed email address before reporting spam

Hello,

After forming a union in the geometry, comsol sometimes gives the message of "Using conservative strategy on domain" or "Warning: Low minimum element quality". What do these messages mean? Can I just ignore them?

Thank you very much

Regards,
Shujun

2 Replies Last Post 02.11.2016, 10:49 GMT-4
COMSOL Moderator

Hello Shujun Xian

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 8 years ago 02.11.2016, 04:07 GMT-4
same question
same question

Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 02.11.2016, 10:49 GMT-4
The message “Using conservative strategy on domain” appears in the log when the ordinary algorithm for the advancing front triangular mesher fails. The software then falls back to a different algorithm. This message is a notification. You can ignore it if things are otherwise fine in your model.
Best regards,
Jeff
The message “Using conservative strategy on domain” appears in the log when the ordinary algorithm for the advancing front triangular mesher fails. The software then falls back to a different algorithm. This message is a notification. You can ignore it if things are otherwise fine in your model. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.